Three-head mini shaver Travel Razor, Mini Shaver Type-Cinterface, fast charge

Mini-3 HeadElectric Shaver Product Description:

Product structure diagram
1. Magnetic protection cover
2. knife net/magnetic knife bit
3. Color indicator (Charging/Working/Unlocking Machine)
4. Charging interface
5. Switch on/off/travel lock key
6. Charging cable

7. Cleaning brush

Basic parameter
*Product name: Mini 3-head electric shaver
*Input voltage: 5V/1A
*Charging time: 1.5 hours
*Rated power: 5W
*Battery capacity: 600mAh

Product Usage Instructions
1.Remove the protective cover, press the open key to start the shaver, and the colorful lights turn on and rotate. To stop working, press the ON key again to turn it off.
2.Move the razor head against the growth direction of the beard on the skin, and  make a straight and winding movement, on the dry face，The shaving effect is better, so shaving is performed for a period of time before or after washing the face.
3.Turn off the razor and cover the protective cover to prevent damage to the knifenet.

Travel lock function
1.Locking travel locks: Press and hold the on key for 3 seconds when the switch is locked and the red light blinks for 3 times. After the switch is locked, the switch motor does not work and enters the travel lock state.

Charging/plug-in use
1.Verify that the machine is off and plug the USB power charger into a power outlet.

Indicator light description
1.When powering on: The colorful lights come on and rotate.
2.When charging: The red light is on and the breath is blinking, and the green light is on when it is full.
3.It can also be powered on during charging and supports plug and play.

Disassembling and Replacing the Knife Head
* This machine is a magnetic knife head, which can be directly pulled up and taken down.
* Rotate the cutter mesh locking cover on the cutter head to the left to take it off.
* The knife net can be directly pushed up, the knife net cutter head can be taken out.
* Take out the cutter head directly to replace the new cutter net and cutter head.
* After replacing the knife mesh and head, replace the product in sequence.

1.When cleaning the shaver, remove the power cord before cleaning the machine in water and make sure it is powered off.
2.Wash the shaver head under the tap.
3.Remove the cutter head part, because the cutter head part is magnetic, can be picked up directly.
4.After pulling up, the machine body can be directly flushed with water.
5.The knife head can be washed under the water tap in the reverse direction.
6. The machine can be equipped with a cleaning brush to clean the main body of the dregs.
7. The machine can be equipped with a cleaning brush to clean the dregs of the head part.

Common faults and analysis
Power-on failure: The battery is not charged. Recharge the battery and then power it on.

Poor shaving effect:
1.If the knife mesh is damaged or worn, replace the purchased original knife mesh.
2. The razor blade net becomes dirty, clean the razor blade net before use.
3. The battery is low. Recharge the battery and then power it on.
Charging failure: If the product is faulty, contact the after-sales service department